Sierra Wireless Writing an embedded application loader Manuel d'utilisateur Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 102
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
GHI Electronics,LLC Embedded Master User Manual
Getting Started with Embedded Master
6.3. Powering up
Embedded Master TFT Development System includes the main board with Embedded
Master module placed on it with 4.3” TFT Expansion. It also includes a USB cable.
User can power the board up by anywhere from 9V to 15V DC adapter
or it can be power through USB Connector connected to Virtual COM - in the lower
right corner (X1) -.
Powering the system from the USB cable is not recommended because of the voltage
drop in the USB cables and the USB Hubs. If using USB for power, connect the USB
cable directly to the PC. Connecting both the USB cable to X1 and power source to X7
is completely safe.
6.4. USB Debugging Driver Setup
The default Interface for TinyBooter and TinyCLR (debugging interface) in GHI firmware
with .NET MFW 3.0 is USB - which is exposed in the upper left corner X3 -.
Rev. 2.06 TFT Page 38 of 102 www.ghielectronics.com
9 -15 volt
DC Power
Inner pin is positive
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 101 102

Commentaires sur ces manuels

Pas de commentaire